![]() PPP over Ethernet - DSL broadband connection Static configuration with fixed address and netmaskĪddress and netmask are assigned by DHCPv6 _prefix= 'fd27:70fa:5c1d::/48'Īnd here the same settings as written in /etc/config/network # cat /etc/config/network Here an example network uci subsystem with default settings for a TL-WR1043ND: See also: Scripting interface Example network configuration To view all info about a particular interface (the UCI name not the physical interface), write: ![]() To see a list of interfaces write the following: In such a case it is required to run wifi up after ifup in order to re-establish the bridge connection. Note that wireless interfaces are managed externally and ifup may break the relation to existing bridges. Individual interfaces can be brought up with ifup name or down with ifdown name where name corresponds to the logical interface name of the corresponding config interface section.Īn ifup implies a prior ifdown so there is no need to invoke both when reloading an interface. Rebooting the router is not necessary, but is also another way that will force a configuration reload. Thanks to netifd (Network Interface Daemon), the changed interfaces will be restarted automatically to apply the changes live. If your install does not supply the service command, a reload can be accomplished with: This uci susbsystem is responsible for defining switch VLANs, interface configurations and network routes.Īfter any network configuration change (through uci or otherwise) you need to reload the network configuration in the netifd daemon by writing: ![]() ![]() The central network configuration is handled by the uci network subsystem, and stored in the file /etc/config/network. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |